ETERNUS SF Storage Cruiser V16.9.1 Operation Guide

11.2.3 Changing Administrative Environment

11.2.3.1 Changing IP Address of Server Node

Refer to "11.1.2.2 Changing IP Address of Server Node".

11.2.3.2 Changing Port Numbers of Server Node

When Storage Cruiser's Agent is Installed

Change the port number in the following steps:

1. Change the port number.

   Refer to "Port Number Setting" in "Setup of Storage Cruiser's Agent" in the Installation and Setup Guide to change port numbers.

2. Restart the Storage Cruiser's agent.

Manually Registering

A manually registered server node does not use any port, so that change of port number is not required.

11.2.3.3 SSL Version Settings for Communicating with Supported Devices

To have Storage Cruiser's agent that is used as the Storage Cluster controller communicate with the following monitoring target devices, the Maintenance-Secure TLSv1.2 or later protocol must be enabled in the SSL version setting for communication on the monitoring target devices. Make sure that the Maintenance-Secure TLSv1.2 or later protocol is enabled and if it is not enabled, enable it.

• ETERNUS DX S6/S5/S4/S3 series (excluding the ETERNUS DX60 S5/S4/S3)

• ETERNUS AF All-Flash Arrays