Follow the procedure below to change the port number for Management Server transactions.
Stop the Management Server transaction.
Refer to your cluster software manuals for how to stop the transaction.
Change the port number.
For changing the port number of AdvancedCopy Manager transaction communication service:
In the primary and secondary nodes for Management Server transactions, change the following port number which was set to the %SystemRoot%\system32\drivers\etc\services file.
AdvancedCopy Manager transaction communication service (stgxfws_logicalNodeName)
For changing the port number used by the ETERNUS SF Manager:
Perform the steps 1 to 4 in "Changing Port Numbers Used in Express" in "Changing Port Numbers (Windows)" in the Express Operation Guide.
The "httpd.conf" file described in step 4 exists in the shared disk. Therefore, edit the "httpd.conf" file either the primary or secondary node.
For changing the port number used by Web Console:
Perform the steps 2 to 4 in "Changing Port Numbers Used in Web Console" in "Changing Port Numbers (Windows)" in the Express Operation Guide.
The "server.xml", "httpd.conf", and "postgresql.conf" files exist in the shared disk. Therefore, edit their files either the primary or secondary node.
Start up the Management Server transaction.
Refer to your cluster software manuals for information on how to start up the transaction.
If you have changed the port number of AdvancedCopy Manager transaction communication service in step 2, create the change instruction file for the server information in a node in which the Management Server transaction is running.
Execute the "stgxfwcmmodsrv" command with the -f option specified to change the port number.
When using the replication management function, execute the "swsrprecoverres" command with the -r option and the -h option on the Management Server. Specify the server name of the Managed Server running the replication operation with the -h option.
Refer to "Command References" in the AdvancedCopy Manager Operation Guide (for Windows) for information on the commands.
Perform the following procedures using Web Console to reload the server configuration information.
On the global navigation tab, click Server.
The registered server list is displayed on the Main pane.
On the Main pane, check the target server checkbox.
On the Action pane, click Reload Conf. under Server.
