3.2 Installation Procedure of ETERNUS SF Manager (for Windows)

The installation procedure of ETERNUS SF Manager (for Windows) is performed as follows:

Note

If customization in Windows Server Failover Clustering is implemented by a user belonging to the Administrators of the domain, the Windows "Computer Browser Service" must be running. If the other products are not using "Computer Browser Service", after this operation is completed, "Computer Browser Service" can be stopped without causing any problems.
Do not use the Telnet Server service.

Perform the following steps on the primary node.
1. Install ETERNUS SF Manager. However, do not install it on a shared disk.
  Refer to "Installation of ETERNUS SF Manager" in the Installation and Setup Guide for details.
2. Set up ETERNUS SF Manager.
  Refer to "Setup of ETERNUS SF Manager" in the Installation and Setup Guide for details. However, the procedures of "Settings Required to Register Storage Devices (When Using the ETERNUS DX S2 series Only)" and "Updating Management Server IP address information" are not required.
3. Create a shared disk.
4. Stop the following services.
  After stopping these services, change the settings for their startup type to "Manual".
  - ETERNUS SF Manager Apache Service
  - ETERNUS SF Manager Tomcat Service
  - ETERNUS SF Manager Postgres Service
  - ETERNUS SF Storage Cruiser Optimization Option
Perform the following steps on the secondary node.
1. Install ETERNUS SF Manager. However, do not install it on a shared disk.
  Refer to "Installation of ETERNUS SF Manager" in the Installation and Setup Guide for details.
  For the installation target, specify the same path as the one specified for the primary node.
2. Set up ETERNUS SF Manager.
  Refer to "Setup of ETERNUS SF Manager" in the Installation and Setup Guide for details. However, the procedures of "Settings Required to Register Storage Devices (When Using the ETERNUS DX S2 series Only)" and "Updating Management Server IP address information" are not required.
3. Stop the following services.
  After stopping these services, change the settings for their startup type to "Manual".
  - ETERNUS SF Manager Apache Service
  - ETERNUS SF Manager Tomcat Service
  - ETERNUS SF Manager Postgres Service
  - ETERNUS SF Storage Cruiser Optimization Option