When copying to the physical environment of PRIMERGY/PRIMEQUEST, check the following and add/configure settings as necessary.
Copying to PRIMERGY(without RX4770M3, RX1330M3, TX1320M3, TX1330M3)
Make sure that the following prerequisite software has been installed:
OS Status Notification
If not, download from "PRIMERGY Tools" - "PRIMERGY Specific Software" on UpdateSite and install it.
Copying to PRIMEQUEST 3000 series
Make sure that the following prerequisite software has been installed:
HBA blockage function
If not, refer to the following manual to install and set up it.
"PRIMEQUEST 3000 SERIES HBA blockage function USER'S GUIDE"
When copying from a PRIMERGY/PRIMEQUEST physical environment to a different environment, check the following and delete if necessary.
Copying from the PRIMEQUEST 3000 series to other environments
For information on how to remove it, see the following documentation:
"PRIMEQUEST 3000 SERIES HBA blockage function USER'S GUIDE"
Copying from PRIMERGY (Excluding RX4770M3, RX1330M3, TX1320M3, TX1330M3) to other environments.
During system startup, the OS status notification function FJSVossn.service might fail to start and the following message might be output, but this does not affect the system.
[FAILED] Failed to start OS Status Notification
