9.6.3 Deleting iSCSI Target Settings

When deleting all the configurations of the mirroring among servers, after deleting the iSCSI initiator settings on all the node, iSCSI target settings must be deleted by the following procedure.

See

For the deletion procedure of iSCSI initiator settings, refer to "9.6.2 Deleting iSCSI Initiator Settings."

Delete the iSCSI target on both nodes.

Execute the following command on both nodes.

# targetcli /iscsi delete target_name

[Execution example]

# targetcli /iscsi delete iqn.2003-01.org.linux-iscsi.node1.x8664:sn.2613f8620d98

Delete the storage settings on both nodes.
Execute the following command on both nodes.
If there are multiple storages, execute this command for each storage.
```
# targetcli /backstores/block delete storage_name
```
[Execution example]
```
# targetcli /backstores/block delete storage1
```

Confirm that the setting was deleted on both nodes.

Execute the following command on both nodes.

# targetcli ls

[Output example]

o- / ................................................................................. [...]
  o- backstores ...................................................................... [...]
  | o- block .......................................................... [Storage Objects: 0]
  | o- fileio ......................................................... [Storage Objects: 0]
  | o- pscsi .......................................................... [Storage Objects: 0]
  | o- ramdisk ........................................................ [Storage Objects: 0]
  o- iscsi .................................................................... [Targets: 0]
  o- loopback ................................................................. [Targets: 0]

Save the target information on both nodes.
Execute the following command on both nodes.
```
# targetctl save
```
Delete the directory for setting related to the start and stop order for iSCSI target service.
Execute the following command on both nodes.
```
# rm -rf /etc/systemd/system/fjsvsdx.service.d/
```
Apply the start and stop order for iSCSI target service.
Execute the following command on both nodes.
```
# systemctl daemon-reload
```
Confirm the start and stop order for iSCSI target service.
Execute the following command on both nodes.
```
# systemctl show fjsvsdx.service | grep "After="
After=iscsi-shutdown.service iscsi.service ...
```
Point
Confirm that target.service is not output.
The following procedure must not be performed on nodes where programs other than GDS use iSCSI target (LIO).
Set up to avoid the automatic startup of iSCSI target service when starting the system.
Execute the following command on both nodes.
```
# systemctl disable target.service
```