After a device is added to any Managed Server, incorporate it into the backup as described below.
This process can be carried out using either Web Console or commands.
For information on adding a device using commands, refer to the following steps:
Execute the stgxfwcmsetdev command in the AdvancedCopy Manager Operation Guide for the OS of the Management Server to acquire information for the newly added device, and accept management information.
Execute the swstdevinfoset command to set up the operation type of the added device.
If the added device was defined as a transaction volume, execute the swstbkpolset command to set up the backup policy.
Note
System resources such as disk and memory resources may be insufficient when a device is added. Re-estimate the system resource requirements before adding a device.
Refer to "Required Resources for Operation" in "Operating Environment of AdvancedCopy Manager's Agent" in the Installation and Setup Guide for details.
