This software supports fault management (SNMP Trap monitoring only) for the ETERNUS CS800 M1/CS800 S7/CS800 S6.
Connecting to the network
At the device, perform the network connection settings to connect to the network. Refer to the manuals of the device for details on how to perform it.
SNMP Trap setting
Perform the setup of the SNMP Trap transmission destination for the device so that SNMP Traps of the device can be transmitted to the Management Server. If the Management Server is operated in a cluster configuration, set the logical IP address of the cluster as the destination.
Registering the device
Refer to "5.2.7 Registering Manually Embedded Device" for registering the device.
Specify the IP address of the device during the registration operation.
