Top
ETERNUS SF Storage Cruiser V16.9 Operation Guide
FUJITSU Storage

3.3.1 Support Level A and B for Switch Management

The range of operating capabilities for the switch depends on the user's security level. Configure the user's settings accordingly.

The operating capability differences, depending on the security level of the specified user, are as follows:

Features

User with Administrator Permissions
(*1)

User with Permissions Other Than Administrator Permissions
(*1)

Device detection, automatic registration, registration deletion

Can be used

Can be used (*2)

Configuration Management

Acquire physical connection

Can be used

Can be used

Access path management (status display)

Can be used

Can be used

Operating Beacon

Can be used (*4)

Cannot be used

Access path management (set/delete/inherit)

Can be used

Cannot be used (*3)

Fault Management

SNMP Trap monitoring

Can be used

Can be used

Device polling monitoring

Can be used

Can be used

Acquiring device status

Can be used

Can be used

Setting the SNMP Trap destination address

Can be used

Cannot be used

Performance Management

Can be used

Can be used

*1: The operating capabilities differ according to the support level.

*2: When performing a device registration using SNMPv1, change the SNMP Community name on the switch information change screen.

Configuration Items

Configuration Details

SNMP Community name (Write)

SNMP community name in the Write direction.
The device registration is set to "private". Change this to "public".

Refer to "Change FC Switch Information" in the Web Console Guide for the operation details.

*3: Zoning information cannot be set or deleted in relation to the switch. For this reason, when setting/deleting/inheriting the access path for this product, set/delete the zoning information in relation to the switch in advance. When the zoning information is not set/deleted in advance, an error occurs in the operation results. When an error occurs without the zoning information being set/deleted in advance, perform setting/deletion of zoning information in relation to the switches on the access path route and perform the Reload Conf. operation in relation to the relevant switches.

*4: Only when performing a device registration using SNMPv1.