Top
ETERNUS SF Express V16.9 / Storage Cruiser V16.9 / AdvancedCopy Manager V16.9 Installation and Setup Guide
FUJITSU Storage

4.3.1 Configuring Network Environment

If you set up firewalls between the Management Server and Managed Servers, as well as between the Management Server and an ETERNUS Disk storage system, set the following port numbers so as to allow transmissions to pass the firewalls.

Port Number/Protocol

Communication Start Direction

Function

161/udp

From Management Server to ETERNUS Disk storage system

Configuration management
Performance management
Polling

162/udp

From ETERNUS Disk storage system to Management Server

Fault management

1372/tcp (*1)

From Management Server to ETERNUS Disk storage system

Configuration management (*3)
Performance management (*3)

1999/tcp (*2)

From Management Server to ETERNUS Disk storage system

Configuration management

22/tcp

From Management Server to ETERNUS Disk storage system

Configuration management (*3)
Performance management (*3)

23/tcp

From Management Server to ETERNUS Disk storage system

Configuration management (*4)

*1: For Maintenance-Secure connection
*2: For Maintenance connection
*3: For the ETERNUS DX series (excluding the ETERNUS DX60 S2), ETERNUS AF All-Flash Arrays, and ETERNUS DX200F
*4: For the ETERNUS DX60 S2

Note

  • For registering a license to ETERNUS Disk storage system, enable the ssh connection or the telnet connection in setting up interface on the ETERNUS Disk storage system.
    Available types of connections vary with the model of ETERNUS Disk storage system. Refer to [Note] in "A.3 Operation of License Management Function" for details.

  • To start Storage Cruiser's manager, map the host name of Storage Cruiser's manager to the corresponding IP address of it for host name resolution. There are methods to map them such as registering them to DNS or describing them in the "hosts" file.

  • Check the settings of communication mode between Management Server and ETERNUS Disk storage system. If either communication mode of the Management Server or the ETERNUS Disk storage system is set to "Full (full duplex)", do not set the other to "Auto Negotiation".

See

Refer to "Network Requirements" in the Storage Cruiser Operation Guide for information on port numbers used by Storage Cruiser's manager.