With Web Console, it is necessary to register ETERNUS Disk storage system to be used.
The following procedure is required to register the target ETERNUS Disk storage system. This procedure should be performed by the system administrator.
Execute the following preparations for each ETERNUS Disk storage system to be registered.
Using ETERNUS Web GUI, perform the following settings. Refer to the ETERNUS Web GUI manual for information on each setting.
Check the IP address of the Management Server.
If there is a Management Server on a subnet different from the subnet for which ETERNUS Disk storage system is set up, check that the IP address of the Management Server is registered to the "Allowed IP List" in the Set Network Environment screen on ETERNUS Web GUI.
If it is not registered to the list, register the IP address of the Management Server to the "Allowed IP List".
Enable the SNMP function of MNT port on the following screen.
Target Device | Name of Screen |
|---|---|
ETERNUS DX60 S5/S4/S3 | Setup SNMP Agent User |
ETERNUS DX60 S2 | Setup SNMP Agent (Basic Interface) |
Check the ETERNUS Disk storage system name displayed in the Name column on the Modify Storage System Name screen.
When using Advanced Copy functions, specify 16 or less alphanumeric characters for ETERNUS Disk storage system name.
If you connect iSCSI, specify "Enable" the use of iSNS server in the target port.
Additionally perform the following settings for the storage devices other than the ETERNUS DX60 S2:
On the following screen of ETERNUS Web GUI, create a new SSH server key. The number of bits for the key is at your discretion.
Target Device | Name of Screen |
|---|---|
ETERNUS DX60 S5/S4/S3 | Setup SSH Server Key |
ETERNUS DX80 S2 | Create SSH Server Key |
On the Setup User Account screen of ETERNUS Web GUI, create a Software Role Account.
In later procedures, specify the account information you created here.
When managing devices using SNMPv1, you must set the SNMP community name on the ETERNUS Disk storage system. Set the SNMP community name on the Setup SNMP Agent Community screen of ETERNUS Web GUI.
When managing devices using SNMPv3, you must set the SNMP user name on the ETERNUS Disk storage system. Set the SNMP user name on the Setup SNMP Agent User screen of ETERNUS Web GUI.
Launch Web Console, and then register the target ETERNUS Disk storage system.
See
Refer to "Register ETERNUS Disk Storage System" in the Web Console Guide for information on the procedure.
