For the detail on how to build the cluster application, refer to "Chapter 6 Building Cluster Applications" in "PRIMECLUSTER Installation and Administration Guide."
Set the shared disk of GDS in this setting.
It is not necessary to set "6.2 Initial GLS Setup" in "PRIMECLUSTER Installation and Administration Guide" because it has been already set in "15.7.1 Initial GLS Setup" above.
Note
If the icmp communication between cluster nodes is not allowed in the firewall configuration, the following message is displayed when the clchkcluster command is executed.
Admin IP <IP address> used by SF is not alive.If this message is output, refer to "14.3.2.1 Firewalls Applied to the Cluster Node", and set the icmp protocol rule to allow the icmp communication between cluster nodes. After that, execute the clchkcluster command again.