ETERNUS SF Storage Cruiser V16.9 Operation Guide

11.2.3 Changing Administrative Environment

11.2.3.1 Changing IP Address of Server Node

Refer to "11.1.2.2 Changing IP Address of Server Node".

11.2.3.2 Changing Port Numbers of Server Node

When Storage Cruiser's Agent is Installed

Change the port number in the following steps:

1. Change the port number.

   Refer to "Port Number Setting" in "Setup of Storage Cruiser's Agent" in the Installation and Setup Guide to change port numbers.

2. Restart the Storage Cruiser's agent.

Manually Registering

A manually registered server node does not use any port, so that change of port number is not required.

11.2.3.3 Changing the SSL Version Settings for Communicating with Supported Devices

If you change the SSL version setting for communicating with the following devices that are set as objects monitored by Storage Cluster Controller, restart the Storage Cruiser's agent if the protocol Maintenance-Secure TLSv1.2 is disabled, or TLSv1.2 and TLSv1.1 are disabled:

• ETERNUS DX S5/S4/S3 series (excluding the ETERNUS DX60 S5/S4/S3)

• ETERNUS AF All-Flash Arrays

• ETERNUS DX200F