The procedure to display the virtual hard disk of Hyper-V host list/details is as follows:
To display the list, perform from step 1 to step 5.
To display the specific virtual hard disk of Hyper-V host details, perform all steps.
On the global navigation tab, click Server.
The registered servers are displayed on the Main pane.
On the Main pane, click the target server name.
On the Category pane, click Correlation.
The items of the Category pane change into the items concerning the correlation management.
On the Category pane, click End to End View (Hyper-V).
On the Main pane, click the End to End View (Hyper-V) - Virtual Hard Disk tab.
On the Main pane, click the target information radio button.
On the Action pane, click Display Details under End to End View (Hyper-V).
The detailed information is displayed on the Main pane. If switching the tabs on the Main pane, the detailed information.
Note
If all of the following conditions are satisfied, the virtual hard disk is not displayed on the End to End View for Hyper-V if a Failover/Failback is executed:
TFOV is used for the virtual hard disk.
An iSCSI port is used for a CA port pair in a Storage Cluster environment.
The IP address of the iSCSI port does not match that in the Primary Storage and the Secondary Storage.
To display the virtual hard disk on the End to End View for Hyper-V after a Failover/Failback has been executed, perform the procedure in "11.5.7 Register/reload Hyper-V Host".
