The procedure to add HBA to the registered server is as follows:
On the global navigation tab, click Server.
The registered servers are displayed on the Main pane.
On the Main pane, click the target server name.
The detailed information of the server and information about HBAs installed in the server are displayed on the Main pane.
On the Action pane, click Add under HBA.
The information input screen is displayed.
Enter the necessary information, and then click Next.
The information confirmation screen is displayed.
Confirm the information, and then click Add.
Point
The interface which can be selected in the HBA adding operation is as follows.
Server Status | Interfaces Can Be Added |
|---|---|
Managed Server of both Storage Cruiser and AdvancedCopy Manager | iSCSI and SAS (An HBA of FC is automatically detected by registering a server or reloading server configuration information.) |
Managed Server of Storage Cruiser | |
Managed Server of AdvancedCopy Manager | FC, iSCSI and SAS |
Server registered in Express | |
Manually embedded device of Storage Cruiser |
Note
If an HBA whose interface is iSCSI is a dual stack device to which both IPv4 and IPv6 addresses are configured, register either of the two addresses.
