The procedure to change the Affinity/LUN group settings is as follows:
On the global navigation tab, click Storage.
The registered ETERNUS Disk storage systems are displayed on the Main pane.
On the Main pane, click the target ETERNUS Disk storage system.
On the Category pane, click Connectivity.
The items of the Category pane change into the items concerning the connectivity.
On the Category pane, click Affinity/LUN Group.
The Affinity/LUN group list is displayed on the Main pane.
On the Main pane, check the target Affinity/LUN group checkbox.
On the Action pane, click Modify under Affinity/LUN Group.
The information input screen is displayed.
When adding volumes, specify with either Specify Volume Range tab or Select Volume tab, and then click Add.
The volumes are added on the Assigned Volumes.
When deleting volumes, check the volume checkbox to delete on the Assigned Volumes.
Click Next.
The information confirmation screen is displayed.
Confirm the information, and then click Modify.
Information
From the Assigned column of the volume list on Define LUN Mapping and Assigned Volumes in the above step 7, you can check whether the volume is assigned to other Affinity/LUN group.
Displayed Strings | Explanation |
|---|---|
Assigned | Volumes assigned to other Affinity/LUN groups. |
No use | Volumes not assigned to other Affinity/LUN groups. |
Note
Operations that modify the affinity group for the BS2000 can be performed only in environments where the following storage devices are connected to the BS2000:
ETERNUS DX S5 series
ETERNUS DX8000 S4 series
ETERNUS DX S4/S3 series with a firmware version V10L80 or later (excluding the ETERNUS DX8000 S4 series)
ETERNUS AF All-Flash Arrays with a firmware version V10L80 or later
ETERNUS DX200F with a firmware version V10L80 or later
