ETERNUS SF Express V16.9 / Storage Cruiser V16.9 / AdvancedCopy Manager V16.9 Web Console Guide

9.11.3 Change FC/iSCSI/SAS Port Settings

The procedure to change the FC/iSCSI/SAS port settings is as follows:

1. On the global navigation tab, click Storage.
   The registered ETERNUS Disk storage systems are displayed on the Main pane.

2. On the Main pane, click the target ETERNUS Disk storage system.

3. On the Category pane, click Connectivity.
   The port type list is displayed on the Main pane.

4. On the Main pane, click the digit of the Number of Ports field for the target port.
   The target port list is displayed on the Main pane.

5. On the Main pane, check the target port checkbox.

6. When changing a FC port, click the target action under Port on the Action pane.
   The information input screen is displayed.

7. Enter the necessary information, and then click Modify.

Point

The setting of the basic IP address #0 information can be changed when Multi-VLAN function of the iSCSI port is enabled.

Note

• The deletion and preservation information when the FC port mode or the iSCSI port mode is changed are as follows.

  Port Mode Before It Changes	Port Mode After Change
  	CA	RA	CA/RA
  CA	-	Host Affinity/LUN Mapping information is deleted	Host Affinity/LUN Mapping information is preserved
  RA	REC path information is deleted	-	REC path information is preserved
  CA/RA	Host Affinity/LUN Mapping information is preserved REC path information is deleted	Host Affinity/LUN Mapping information is deleted REC path information is preserved	-

• When the FC port mode is changed, FC port setting returns to initial value.

• When the iSCSI port mode is changed, iSCSI port setting returns to initial value.

• Refer to [Note] in "Connectivity Management" in the Storage Cruiser Operation Guide for the conditions related to the iSCSI port setting.

• If the port is iSCSI-RA, Transfer Rate and iSCSI Name cannot be changed by Web Console.
  If it needs to be changed, use ETERNUS Web GUI.