The procedure to display/set REC path is as follows:
To display the REC path list, perform from step 1 to step 4.
To set the REC path, perform all steps.
On the global navigation tab, click Storage.
The registered ETERNUS Disk storage systems are displayed on the Main pane.
On the Main pane, click the target ETERNUS Disk storage system.
On the Category pane, click Advanced Copy.
The items of the Category pane change into the items concerning Advanced Copy.
On the Category pane, click REC Path.
The created REC path list is displayed on the Main pane.
On the Action pane, click Set under REC Path.
The screen to select remote partner is displayed.
Select the remote copy destination ETERNUS Disk storage system, and then click Next.
The REC path setting screen is displayed.
Select remote copy route and connection type between ETERNUS Disk storage systems, and then click Set.
Note
A local device port for which "RA" or "CA/RA" is displayed in the Mode field can be selected as a remote copy route.
A remote device port for which "RA" or "CA/RA" is displayed in the Mode field can be selected as a remote copy route.
The settings of the compression ratio of REC path is enabled only when the one or more REC paths have been added.
When the deletion of the existed REC path is only executed, the specified compression ratio is not set.
To set a Bandwidth Limit with Web Console, both the local and remote disk storage systems must support Bandwidth Limit. Use ETERNUS Web GUI when setting a Bandwidth Limit for paths that are mixed with devices that do not support Bandwidth Limit.
The copy destination device should have the same IP address version as the copy source device (both should have either IPv4 or IPv6).
