ETERNUS SF Express V16.9 / Storage Cruiser V16.9 / AdvancedCopy Manager V16.9 Release Notes

2.4.24 Copy Progress Rate of QuickOPC

The information on the copying progress rate of QuickOPC, which is displayed when executing below commands, has been changed:

• AdvancedCopy Manager commands

  • For all platforms

    • Execute column of the "swstbackstat" command

    • Execute column of the "swsthistdisp" command

    • Execute column of the "swstexecstat" command

    • Execute column of the "swsttrkstat" command

    • Execute column of the "swsrpstat" command

  • For Windows only

    • Execute column of the "swsrpshadowadm_exchange" command

    • Execute column of the "swsrpvrq advcopy query" command

• AdvancedCopy Manager Copy Control Module command

  • Progress column of the "acopc query" command

Version	Details
15.1 or later	Excluding the following storage devices, if you write data onto a copy source volume while physical copying of QuickOPC is in progress, a progress rate of 100% is displayed after completing physical copying: ETERNUS DX60 S2 ETERNUS DX80 S2/DX90 S2 (Firmware version is earlier than V10L30) ETERNUS DX400 S2 series (Firmware version is earlier than V10L30) ETERNUS DX8000 S2 series (Firmware version is earlier than V10L30) ETERNUS DX60/DX80/DX90 ETERNUS DX400 series ETERNUS DX8000 series ETERNUS2000, ETERNUS4000, ETERNUS8000
15.0 or earlier	If you write data onto a copy source volume while physical copying of QuickOPC is in progress, the displayed progress rate does not reach 100% after completing physical copying.