2.3.32 Sanadmsh Chtraprcvip Command Format

The values that can be specified for DeviceID operand of the "sanadmsh chtraprcvip" command have changed.

Version	Details
16.0 or later	The following can be specified as a device type: -all -host -storage -library -switch If "-all" is specified as a device type, it is unnecessary to specify the way to identify a device. If a value other than "-all" is specified as the device type, specify either of the following as the way to specify a device: ip: IP address of a device sysname: SysName name of SNMP that is set to the device
15.3 or earlier	The following can be specified as a device type: -host -storage -library -switch -hub -bridge Specify one of the following as the way to identify a device: ip: IP address of a device sysname: SysName name of SNMP that is set to the device nickname: Device management name that is set for this software

Version

Details

16.0 or later

The following can be specified as a device type:

-all
-host
-storage
-library
-switch

If "-all" is specified as a device type, it is unnecessary to specify the way to identify a device. If a value other than "-all" is specified as the device type, specify either of the following as the way to specify a device:

ip: IP address of a device
sysname: SysName name of SNMP that is set to the device

15.3 or earlier

The following can be specified as a device type:

-host
-storage
-library
-switch
-hub
-bridge

Specify one of the following as the way to identify a device:

ip: IP address of a device
sysname: SysName name of SNMP that is set to the device
nickname: Device management name that is set for this software

See

Refer to "Command References" in the Storage Cruiser Operation Guide for information on the command.