PRIMECLUSTER Global Link Services Configuration and AdministrationGuide 4.6Redundant Line Control Function

G.3.7 Enabling the changed setting

After the IP address is changed in the copy destination system, restart OS to check if the IP address is changed properly. Take the following step.

1. Starting OS in multi user mode

   Restart OS in multi user mode.

2. Checking the IP address

   After OS is restarted, check if the changed IP address is enabled. Check if the following procedure is complete.

   • The changed IP address is set for each physical interface and for each virtual interface.

   • The changed static route information including the default gateway for each routing table.

   • The changed IP address is set for the monitoring target IP address and the monitoring works properly (in NIC switching mode and virtual NIC mode).

   • The IP address of the communication target The changed IP address is set for the IP address of the communication target, and the monitoring works properly (in GS linkage mode).

   • After RMS is started, the changed takeover IP address is set for the active node of the cluster. After that, when the node is switched, the changed takeover IP address is set for the standby node (in cluster system).