Error message
0225 The job net is being saved or controlled. |
Applicable versions and levels
Windows versions: V5.0L10 or later
Solaris versions: 5.0 or later
Linux versions: 5.2, V10.0L10 or later
Linux for Itanium versions: V12.0L10 or later
HP-UX versions: 5.1 or later
AIX versions: 5.1 or later
DS versions: V20L10
Action 1
Points to check
Does one of the following apply?
The operation was performed immediately after the operation target job net ended
The same job net was operated at the same time
An operation such as start was performed immediately after the job net was copied
Cause
The Jobscheduler service/daemon or other Jobscheduler command performs processing for the operation target job net while it was being saved or controlled.
This message may be displayed in the job net Completed exit or Abended exit when you try to delete a job net that has itself ended.
Action method
Wait for a while (a few seconds) until the Jobscheduler service/daemon or other Jobscheduler command processing is complete, and then reexecute the operation.
By creating an exit program so that the retry is performed a finite number of times every few seconds, it may be possible to avoid this problem.
Action 2
Points to check
Is a nested job net defined in the same definition file?
Cause
In the change processing of nested job nets, if you change a parent job net, the startup days may be re-created (change of job net). Following that, it is not possible to make changes to child job nets and linked job nets.
Action method
The job net control statements of child job nets and linked job nets must precede the job net statements of parent job nets in the definition file.
Action 3
Points to check
Are job nets using the base job net and startup day of the base job net defined in the same definition file?
Cause
In the change processing of base job nets, the startup day of job nets using the startup day of the base job net may be re-created (change of job net). In such cases, job nets using the base job net cannot be changed at the same time.
Action method
Define the job net control statement that is using the base job net and the startup day of that base job net in a separate definition file.
