You can use the following configuration of the cluster system. Use PRIMECLUSTER Designsheets to design the system in either case.
Virtual Machine function not used
Virtual Machine function used
The installation of the PRIMECLUSTER system is based on created PRIMECLUSTER Designsheets. Make sure to create the designsheet.
See
For details on the operation environment, see "Chapter 2 Operation Environment" in the Installation Guide for PRIMECLUSTER.
Information
When using the virtual machine function in a VMware environment, see "Appendix H Using PRIMECLUSTER in a VMware Environment."
When using PRIMECLUSTER in an RHOSP environment, see "Appendix I Using PRIMECLUSTER in RHOSP Environment."
Note
Do not set cipX (X is a number from 0 to 7) for the device name of the network device that exists in the system.
PRIMECLUSTER creates and uses cipX as the name of the virtual network device. Thus, if cipX has already existed as the name of the network device, PRIMECLUSTER cannot be set nor operated.
Do not set cipX (X is a number from 0 to 7) for the connection.id of NetworkManager that exists on the system in RHEL8 or later.
PRIMECLUSTER uses cipX as the connection.id. Thus, if cipX has already existed as the connection.id, cip will not set. If cipX has already been used as the connection.id, change it.
