In Redundant Line Control function 4.5A00, the following commands are incompatible commands from the previous versions.
In addition, please refer to "Chapter 7 Command reference" about the details of each command.
[Contents]
The initial setting of the '-d' option (the inactivation method of the standby interface) of the hanetparam command is changed to "plumb."
[Changes]
Before modification
The '-d' option for the hanetparam command is initially set to "unplumb."
After modification
The '-d' option of the hanetparam command is initially set to "plumb."
[Contents 1]
The initial setting of the '-I' option (the link based failure detection settings) of the hanetpoll on command is changed to "yes."
[Changes 1]
Before modification
The '-I' option of the hanetpoll on command is initially set to "no."
After modification
The '-I' option of the hanetpoll on command is initially set to "yes."
[Contents 2]
Up to two monitoring destinations can be specified using the '-p' option of the hanetpoll create/modify commands for the virtual interface of a single physical interface configuration.
[Changes 2]
Before modification
Only one monitoring destination can be specified using the '-p' option of the hanetpoll create/modify commands for the virtual interface of a single physical interface configuration.
After modification
Up to two monitoring destinations can be specified using the '-p' option of the hanetpoll create/modify commands for the virtual interface of a single physical interface configuration.
