PRIMECLUSTER Web-Based Admin ViewOperation Guide 4.6

7.4.1 Setup by command

Procedure:

1. Stop Web-Based Admin View on all the monitored nodes that might become the secondary management server.

   Refer to "6.1 Stop".

2. Determine a potential monitoring node of the secondary management server.

   Execute the following command on all the monitored nodes that might become the secondary management server:

   # /etc/opt/FJSVwvbs/etc/bin/wvSetparam server-election on

3. Restart Web-Based Admin View on all the monitored nodes that might become the secondary management server.

   Refer to "6.2 Restart"

4. Set up a group address.

   Execute the following command on the primary management server to set up a group address:

   # /etc/opt/FJSVwvbs/etc/bin/wvSetparam group-addr <group address>

5. Set the secondary management server to the mode in which a dynamic decision is available.

   Execute the following command on the primary management server:

   # /etc/opt/FJSVwvbs/etc/bin/wvSetparam server-ha on

6. To validate the setup, restart Web-Based Admin View on all the management servers and monitored nodes.

   Refer to "6.2 Restart".

Information

When a multicast address for IPv4 is set to a group address, for example, the IP address of the primary management server is 10.20.30.40, override 231.20.30.40 by changing "10" to "231."

For details of the group address information, refer to "RFC1700".