The replication function is used to restore a system volume.
Figure D.4 Restoring System Volume
The restoration procedure is as follows:
Stop the restoration target server.
After the server stops, check that the server power is off.
If the system volume on the restoration target server is unusable because of a hardware failure, recover the system volume so that the data can be restored.
On the server used for restore operations, execute the swsrpmake command with replication in the reverse direction.
# /opt/FJSVswsrp/bin/swsrpmake -m SBKVOL@SBK-SV SYSVOL@TRG-SV |
The swsrpmake command operand was specified in the format "volume name@Managed Server name", as shown in the examples below.
name of backup/restore target server: TRG-SV
name of system volume: SYSVOL
name of server that performs the backup/restore operation: SBK-SV
name of backup volume: SBKVOL
Activate the restoration target server.
