This section explains the 677XX message series.
Description
The operation cannot be performed because locked resources are contained in obj which is to be used for the requested operation.
Corrective Action
Specify resources which are not locked and then perform the operation.
When an error occurred while modifying the network configuration of a Physical L-Server
The configuration of the Physical L-Server cannot be changed because the configuration includes a locked network resource.
Specify a network resource which is not locked.
Description
A combination of resources with different site attributes has been specified as target resources.
Corrective Action
Select resources which have the same site attributes and then perform the operation again.
Description
The virtual storage vstorage is being used not only by resource 2 which belongs to the tenant specified in the command or is contained in the resources ("global") that do not belong to any tenant, but also by resource1.
For the argument of the command, it is necessary to specify all tenants which have resources using the same virtual storage and resources which do not belong to any tenant ("global").
One of the following is displayed for target:
tenant "tenant_name"
resource1 belongs to the tenant tenant_name.
global
resource1 is the resource which does not belong to any tenant.
Corrective Action
Check if target has been specified for the command argument.
If it has not been specified, add the specification as shown below, and then execute the command again.
When target is tenant "tenant_name"
Add -tenant tenant_name to the command.
When target is "global"
Add -global to the command.
Description
The cloning image cannot be registered with the VM software. The VM files of the cloning images are stored on the virtual storage vstorage1, vstorage2, .... Registration failed because no VM host connected to all virtual storage units can be found.
When this message occurs during DR switchover of virtual L-Servers (VM guests), it is possible that the batch command for switchover was executed without virtual storage mounted on VM hosts.
Corrective Action
Check if the virtual storage displayed in the message has been connected to a VM host which satisfies all of the following conditions:
Power is ON
Monitoring status is normal
Maintenance mode is not set
VM maintenance mode has not been set for the server virtualization software
Modify the settings of the VM host to satisfy these conditions, or connect the virtual storage to a VM host which satisfies these conditions.
When this message occurs during DR switchover of virtual L-Servers (VM guests), mount virtual storage on VM hosts as given in the DR switchover procedure, and then execute the batch command for switchover again.
