Details on incompatibilities 1
To enable the operator intervention request, you have to set the AppWatch parameter to ON with clsetparam. With the default settings made when the cluster was installed, the operator intervention request, is disabled. For details, see "5.2 Setting up Fault Resource Identification and Operator Intervention Request."
Changes
The operator intervention request, is always enabled.
The operator intervention request, is enabled only when the AppWatch parameter is set to ON with clsetparam. The default value of AppWatch set when the cluster was installed is set to OFF, and the operator intervention request, will not work with this default value.
Note
For details, see "4.2 Operator Intervention Messages" in "PRIMECLUSTER Messages."
Details on incompatibilities 2
With the default settings made when the cluster was installed, the operator intervention request is always enabled.
For details, see "5.2 Setting up Fault Resource Identification and Operator Intervention Request."
Changes
The operator intervention request will not work with the default setting at installation.
The default value of AppWatch set when the cluster was installed is set to OFF, and the operator intervention request will not work with this default value.
The operator intervention request will work with the default setting at installation.
The operator intervention request, is disabled only when the AppWatch parameter is set to OFF with clsetparam.
Note
After you have changed the AppWatch parameter with clsetparam, you have to restartt all the nodes to validate the setting.
