The following describes the procedure for swapping HUBs in Fast switching mode and GS linkage mode.
Disconnect the route of the HUB to be swapped.
# /opt/FJSVhanet/usr/sbin/hanetnic delete -n shaX -i ethX |
Swap the HUB
Check that HUB3 has been set correctly.
Execute a command such as the ip command to check the link up status of the physical interface (ethX). If the link up is completed, "LOWER_UP" is displayed when using the ip command.
Reconnect the route of the HUB that was swapped.
# /opt/FJSVhanet/usr/sbin/hanetnic add -n shaX -i ethX |