When you build the PRIMECLUSTER system, the default values for the kernel parameters of the Linux(R) may be inadequate. This worksheet indicates the values for the kernel parameters used in PRIMCLUSTER.
Set an appropriate kernel parameter as follows based on the type of "Characteristics" in each table.
Addition
Set the total number of the recommended values and specified values for system default values and for each software.
Maximum value
Specify the maximum value in the recommended values and specified values for each software.
However, make sure to use the system default value if the maximum value is less than that.
The kernel parameter values differ depending upon:
CF configuration
RMS configuration
Using GFS
Note
The values used by products and user applications that operate in the PRIMECLUSTER system must also be included in the kernel parameter values.
To enable values that have been changed, you must restart OS after the installation.
