You can use the following configuration of the cluster system. Use "PRIMECLUSTER System Design Worksheet" to design the system in either case.
Virtual Machine function not used
Virtual Machine function used
The installation of the PRIMECLUSTER system is based on the completed "Appendix A PRIMECLUSTER System Design Worksheets"
See
For details on the operation environment, see "Chapter 2 Operation Environment" in the Installation Guide for PRIMECLUSTER.
Information
When designing the system on the native machine, it may be helpful to see "A.11 System Design Examples (for the Virtual Machine Function not used)."
When designing the system on the virtual machine function in a KVM environment, it may be helpful to see "A.12 System Design Examples (for the Virtual Machine Function used in KVM Environment)."
When using the virtual machine function in a VMware environment, see "Appendix H Using PRIMECLUSTER in a VMware Environment."
Note
Do not set the name: cipX (X is a number from 0 to 7) for the device name of the network device that exists in the system. Since PRIMECLUSTER creates and uses the name: cipX of the virtual network device, if the name has already existed in the network device, PRIMECLUSTER cannot be set nor operated.
When the NetworkManager service is enabled, PRIMECLUSTER cannot be set nor operated. Check the NetworkManager service setting. If you change the NetworkManager service setting, see the Linux documentation.
