PRIMECLUSTER Installation and Administration Guide 4.4

9.3.3 Changing Blade Settings

This section describes changing Blade settings.

9.3.3.1 Changing the IP Address of the Management Blade

This section explains how to change the IP address of the management blade.

Operation Procedure:

1. Execute the following command on all the nodes to stop the shutdown facility.

   # sdtool -e

2. Change the IP address according to the procedure of the management blade.

3. Define the changed IP address in the Shutdown Agent configuration file.

   See

   For details on how to define the configuration file, see "5.1.2.3.4 Setting up Blade Shutdown Agent."

4. Execute the following command on any node to apply changes of the configuration file.

   # /etc/opt/FJSVcllkcd/bin/panicinfo_setup

   After the following message is displayed, select "I."

   panicinfo_setup: WARNING: /etc/panicinfo.conf file already exists.
   (I)nitialize, (C)opy or (Q)uit (I/C/Q) ?

5. Execute the following command on all the nodes to start the shutdown facility.

   # sdtool -b

6. Execute the following command on all the nodes and check that the shutdown facility operates normally.

   # sdtool -s

   Note

   There is a possibility that the settings of the agent or hardware are not correct when any of the following statuses are displayed though changing the settings of the shutdown facility is completed.

   • InitFailed is displayed in Init State.

   • Unknown or TestFailed is displayed in Test State.

   In this case, review the settings of the agent or hardware.

9.3.3.2 Changing the Slot Number of Server Blades

This section explains how to change the slot number of server blades.

Operation Procedure:

1. Execute the following command on all the nodes to stop the shutdown facility.

   # sdtool -e

2. Change the slot position according to procedure for the server blade.

3. Define the changed slot number of the server blade in the Shutdown Agent configuration file.

   See

   For details on how to define the configuration file, see "5.1.2.3.4 Setting up Blade Shutdown Agent."

4. Execute the following command on any node to apply changes of the configuration file.

   # /etc/opt/FJSVcllkcd/bin/panicinfo_setup

   After the following message is displayed, select "I."

   panicinfo_setup: WARNING: /etc/panicinfo.conf file already exists.
   (I)nitialize, (C)opy or (Q)uit (I/C/Q) ?

5. Execute the following command on all the nodes to start the shutdown facility.

   # sdtool -b

6. Execute the following command on all the nodes and check that the shutdown facility operates normally.

   # sdtool -s

   Note

   There is a possibility that the settings of the agent or hardware are not correct when any of the following statuses are displayed though changing the settings of the shutdown facility is completed.

   • InitFailed is displayed in Init State.

   • Unknown or TestFailed is displayed in Test State.

   In this case, review the settings of the agent or hardware.