PRIMECLUSTER Installation and Administration Guide4.5

J.2.8 Operator Intervention Request

Details on incompatibilities

With the default settings made when the cluster was installed, the operator intervention request is always enabled.

For details, see "5.4 Setting Up Fault Resource Identification and Operator Intervention Request."

Changes

Before upgrading [PRIMECLUSTER 4.3A10]

The operator intervention request will not work with the default setting at installation.

The default value of AppWatch set when the cluster was installed is set to OFF, and the operator intervention request will not work with this default value.

After upgrading [PRIMECLUSTER 4.5A10]

The operator intervention request will work with the default setting at installation.

The operator intervention request, is disabled only when the AppWatch parameter is set to OFF with clsetparam.

Note

After you have changed the AppWatch parameter with clsetparam, you have to restart all the nodes to validate the setting.