After installation of the software products related to PRIMECLUSTER is done, you need to set up the OS and hardware for installing and operating PRIMECLUSTER.
Set up the following if necessary.
If a network adapter for a public LAN has been installed, you need to configure the IP addresses after installing the OS.
Perform this setup after installing the operating system.
For details, see "3.2.1 Setting Up the Network".
This setup synchronizes the time in all of the nodes of the cluster system. This NTP setup needs to be done before installing PRIMECLUSTER.
When using a shared disk unit, you need to install and set up the related software product. This disk unit setup needs to be done before installing PRIMECLUSTER.
For details, see "3.2.2 Setting Up Disk Units".
Kernel parameter check and setup
When operating the software products related to PRIMECLUSTER, you need to adjust kernel parameters according to the hardware configuration and applications. This kernel parameter setup should be done before operating PRIMECLUSTER.
For details, see "3.2.3 Checking and Setting the Kernel Parameters".
Setting I/O Fencing Function of GDS
To use the I/O Fencing Function, make sure to set up the I/O Fencing Function of GDS.
The settings must be completed before restarting the system after PRIMECLUSTER is installed.
For details, refer to "3.2.4 Setting I/O Fencing Function of GDS."
