Number of Required Backup Volumes
Snapshot high-speed backup requires as many backup volumes as the number of specified backup generations. Accordingly, snapshot backup is disabled if:
All the specified number of generations have been backed up, and
There is no new volume that can be used as a backup volume.
Simultaneous Backups
Performing snapshot high-speed backup simultaneously with the same transaction volume specified performs two backups in parallel.
However, performing snapshot high-speed backup simultaneously more often than the number of preservation generations cancels the backup operations starting from the oldest one. In other words, you cannot perform more simultaneous backups than the specified number of generations.
Notes on Combining Cascade Copy and Concurrent OPC in Operation
If you specify a volume used in cascade copy as the copy source and then execute a Concurrent OPC by the swsrpmake command, it may not be possible to preserve the sequence of data updates across multiple volumes.
In this case, an error message is displayed and the command terminates in an error.
If the error cannot be resolved by responding to the message, we recommend you change the operating method of Advanced Copy or reconfigure the system.
If you cannot change the operating method of Advanced Copy or reconfigure the system, create a file (check.ini) that sets the sequence of data updates across multiple volumes. Then, disable sequence preservation before you retry Concurrent OPC. The sequence of data updates is not preserved across multiple volumes.
Create check.ini in the following path of the server on which to execute the swsrpmake command:
In a non-cluster environment
/etc/opt/FJSVswsrp/data/DEFAULT |
In a cluster environment
/etc/opt/FJSVswsrp/logicalNodeName/data/DEFAULT |
Section Name | Key Name | Value |
|---|---|---|
[check] | ConcurOPCCascade | Set preservation of the sequence of data updates across multiple volumes. |
[Example for disabling sequence preservation]
[check] ConcurOPCCascade=No |
Point
For any of the below ETERNUS Disk storage systems, Concurrent OPC can be executed regardless of sequence preservation of data updates. However, the sequence of data updates is not preserved across multiple volumes.
ETERNUS DX80 S2 (for earlier than V10L30 firmware)
ETERNUS DX90 S2 (for earlier than V10L30 firmware)
ETERNUS DX400/DX400 S2 series (for earlier than V10L30 firmware)
ETERNUS DX8000/DX8000 S2 series (for earlier than V10L30 firmware)
