This section explains the error codes output in ACM's inter-server replication function messages.
ERROR: class name too longExplanation
The specified class name is too long.
Resolution
Specify a correct class name.
ERROR: volume name too longExplanation
The specified volume name is too long.
Resolution
Specify a correct volume name.
ERROR: no enough address spaceExplanation
The OS malloc function returned an error.
Resolution
Check whether memory and a swap area are sufficient.
ERROR: cannot start required number of copy sessionsExplanation
The requested number of copy sessions cannot be started.
Resolution
Check the configuration and status of the copy source and the copy destination volumes.
If normal slices composing the copy source or copy destination volume are less than the number of sessions to be started, restore the slice status or change the volume configuration as needed. Alternatively, specify a lower number of sessions not to exceed the number of normal slices of each volume.
ERROR: copy session not foundExplanation
No copy session exists between the copy source and the copy destination volumes.
Resolution
Confirm that there is no error in the configuration and status of the copy source and the copy destination volumes.
ERROR: copy sessions are in inconsistent statusesExplanation
The statuses of copy sessions between the copy source and the copy destination volumes are inconsistent.
Resolution
With the relevant ACM commands, suspend or cancel the EC or REC copying, and start the copying again as needed.