This section explains about the settings to be done after restoring the system disk.
When the shared class or local class of GDS is used, perform the following [Setting procedure] regardless of whether the system disk is mirrored by GDS.
The following procedures include the [Setting procedure] steps. Therefore if the system disk is restored by the following procedures, [Setting procedure] does not need to be performed.
- "6.2.2 Restoring"
- "6.3.2 Restoring (When the System Can Be Booted)"
- "6.3.3 Restoring (When the System Cannot Be Booted)"
Note
After restoring the system disk, perform the following settings before starting up the system in multi-user mode.
[Setting procedure]
1) If "6.1.1 Settings Before Backing Up" is not executed, start up the system in single-user mode and set according to "6.1.1 Settings Before Backing Up."
2) Start up the system in multi-user mode.
3) Check if there are no errors in the configuration and state of the shared and local classes.
# sdxinfo |
4) Undo the configuration parameter settings of GDS.
Comment out the line of SDX_DB_FAIL_NUM=0 in the /etc/opt/FJSVsdx/sdx.cf configuration file.
# vi /etc/opt/FJSVsdx/sdx.cf ... # SDX_DB_FAIL_NUM=0 |
