After starting the virtual appliance for this product, use the Configuration Wizard to perform setup. The procedure is described below.
Log in to the console with the administrator account (administrator) and the default password (Admin123#).
Run csgsetup in the current directory.
When the Configuration Wizard starts, follow the instructions to perform setup.
The default keymap is "us". Please be careful while entering information (e.g. changing password) before setting the keymap.
The following items are displayed:
Change Administrator Password
Change sftpadmin Password
Network selection
Configure DHCP
Setting Hostname
Configure Network(*)
Configure DNS
Configure Domain
Configure Keymap
Configure NTP
Configure time zone
A message is displayed asking you to restart the system. Select OK to restart the system.
Note
A default password is set for the administrator account. For security purposes, be sure to change this password under "Change Administrator Password" of the Configuration Wizard. The password must be between 8 to 64 characters long. You must use at least three of the following four character types: uppercase letters, lowercase letters, numbers, and symbols (!"#$&'()*+,-./@[\]^_`{|}~:;<=>?).
Because a default password is not set for the SFTP account (sftpadmin), SFTP cannot be used by default. To use SFTP, change the password by executing "Change sftpadmin Password" of the Configuration Wizard. The same conditions as the administrator password are applied for the allowed characters. The SFTP account (sftpadmin) is a dedicated account for file transfers using SFTP. Unlike the administrator account, this account cannot be used to log in to the console of this product or transfer files using FTP.
For single network configurations, network selection items are skipped.
If you choose to use DHCP in the DHCP settings, the settings marked with an asterisk (*) are skipped.
Even for multi-network configurations, the Configuration Wizard can only set the first network. For information on setting the second and subsequent networks, refer to 2.8 Configuring Multi-network Configurations.
The following addresses cannot be set as an IP address:
The IP addresses set for the second and subsequent networks
The gateway address set for the second and subsequent networks
The loopback address (127.0.0.1)
Select a network that can communicate with the following types of servers.
DNS server, NTP server, mail server (SMTP server), external authentication server (LDAP server, and Active directory server).
When using an external authentication server, be sure to enable the Network Time Protocol (NTP).
If an external authentication server (Active Directory server) is used with SMB, DNS server settings are required.
