The following describes the procedure for swapping HUBs in Fast switching mode and GS linkage mode.
Disconnect the route of the HUB to be swapped.
# /opt/FJSVhanet/usr/sbin/hanetnic delete -n shaX -i ethX |
Swap the HUB
Check that HUB3 has been set correctly.
Execute a command such as the ifconfig command or the ip command to check the link up status of the physical interface (ethX). If the link up is completed, "RUNNING" is displayed when using the ifconfig command, or "LOWER_UP" up is displayed when using the ip command.
Reconnect the route of the HUB that was swapped.
# /opt/FJSVhanet/usr/sbin/hanetnic add -n shaX -i ethX |
