ServerView Resource Orchestrator Cloud Edition V3.3.0 Automatic Quarantining FunctionUser's Guide

2.4 Installing the Resource Orchestrator Agent

This section explains the procedure for installing the Resource Orchestrator agent.

It is necessary to install agents when using Hyper-V on Windows Server 2016 or SBC servers.

Prerequisites

It is necessary to install ServerView Agents for Windows before installing the Resource Orchestrator agent.

Procedure

Install the Resource Orchestrator agent using the following procedure:

1. Log on to the system as the administrator.

   Log on to the system on which the agent is to be installed using the Administrator account.

2. Set the first Resource Orchestrator DVD-ROM.

   The installer starts automatically.

   Information

   If the installer does not start, execute "RcSetup.exe" from the DVD-ROM drive.

3. Select [Cloud Edition].

4. Click [Agent installation].

5. The Resource Orchestrator setup window is displayed.

   Check the content of the license agreement window, etc. and then click [Yes].

6. Install the manager interactively, following the instructions provided by the installer.

   Window	Entry	Description
   Installation Folder Selection	Installation Folder	This is the folder where Resource Orchestrator is installed. When changing the installation folder, refer to the "Note" below.
   Admin Server Registration	Admin LAN IP Address of the Admin Server	When the admin server has multiple IP addresses, specify the IP address used for communication with managed servers.
   License Authentication	License Authentication Information for the Windows Volume License	When not using cloning Click [Next>] without selecting [Using the cloning feature of this product]. When using cloning Select [Using the cloning feature of this product]. For details, refer to "2.2.2 Installation [Windows] [Hyper-V]" in the "Setup Guide CE".

7. The [Start Copying Files] window will be displayed.

   Check that there are no mistakes in the content displayed on the window, and then click [Install>].

   Copying of files will start.

   To change the content, click [<Back].

8. The Resource Orchestrator setup completion window will be displayed.

   When setup is complete, the setup completion window will be displayed.

   Click [Finish] and close the window.

Note

When changing the folders, be careful about the following points.

• Do not specify the installation folder of the system (such as C:\).

• Enter the location using 100 characters or less. Do not use double-byte characters or the following symbols in the folder name.

• """, "|", ":", "*", "?", "/", ".", "<", ">", ",", "%", "&", "^", "=", "!", ";", "#", "'", "+", "[", "]", "{", "}"

• When using a 64-bit Windows Server OS, the following folder name cannot be specified for the installation folder.

  • "%SystemRoot%\System32\"

• When using cloning, installation on the OS system drive is advised, because Sysprep initializes the drive letter during deployment of cloning images.