Check the following:
The configuration for the admin and public LANs has been designed
The network environment for the admin LAN is configured
The VLAN ID to allocate to the network resource has been configured
The virtual switch has been configured beforehand
Point
When creating a virtual L-Server, for NICs other than the virtual NICs connected to the subnets for the admin LAN of the control domain, pvid is configured for the virtual NIC, and communications are enabled using a tagged VLAN.
Therefore, configure the virtual switch for the virtual L-Server to communicate using a tagged VLAN.
When Using IBP
When using virtual L-Servers, after creating the IBP uplink sets to use for the public LAN and admin LAN, connect the IBP uplink sets to the VM host. It is not necessary to use the same name for the uplink set and the name of the network resource.
Creating a virtual switch
It is necessary to create the virtual switch in OVM for SPARC, in order to connect the L-Server to the network.
For details on how to create a virtual switch, refer to the OVM for SPARC manual.
