This section explains the system configuration when using OVM for SPARC as server virtualization software.
Example of System Configuration
An example system configuration using OVM for SPARC is given below.
Figure E.28 System Configuration Example Using OVM for SPARC
* Note: For details of the required software, refer to "6.1.2.4 Required Software" in the "Overview".
Network Configuration Example
An example network configuration using OVM for SPARC is given below:
Figure E.29 Virtual Switch Settings Using Network Resources
L-Server Creation Procedure
The procedure for creating L-Servers is shown below.
Figure E.30 Resource Orchestrator Setup Procedure
For details on pre-setup preparations, refer to "E.7 OVM for SPARC".
For details on how to install Resource Orchestrator, refer to "Chapter 2 Installation" in the "Setup Guide CE".
For details on setup, refer to "8.8 OVM for SPARC" in the "Setup Guide CE".
For details on how to create an L-Server, refer to "8.8.6 Creating L-Servers" in the "Setup Guide CE".
