Choose values for the following management board settings, given the following criteria:
This name is used to identify the PRIMEQUEST chassis on the admin server. Each chassis name must be unique within the system.
The first character must be alphabetic, and the name can contain up to 10 alphanumeric characters and hyphens ("-").
These IP addresses can be used to communicate with the admin server.
Name of the user account used to log into remote server management and gain control over the managed server.
A user account with at least administration privileges within the remote server management must be specified.
This password must be between 8 and 16 alphanumeric characters long.
Password used to log in the remote management controller with the above user name.
This password must be between 8 and 16 alphanumeric characters long.
This community name can contain up to 32 alphanumeric characters, underscores ("_"), and hyphens ("-").
This must be the IP address of the admin server.
For details on modifying values for monitoring timeout of power control operations, refer to "Changing Monitoring Timeout Values of Physical Server Power Operations" in "Appendix A Notes on Operating ServerView Resource Orchestrator" in the "Operation Guide CE".
Note
To enable server cloning between servers in different chassis, use the same SNMP community for each chassis.
When using a PRIMEQUEST 2000 series, the following partitions can be registered as managed servers.
PPAR partitions with "Extended Partitioning Mode" set to "Disable"
Extended partitions configured on PPAR partitions with "Extended Partitioning Mode" set to "Enable"
Do not change the Extended Partitioning Mode or PPAR Extended Partition configuration after server registration.
When the Extended Partitioning Mode is changed to "Enable" after server registration, "Extended Partitioning Mode" is displayed, but the PPAR cannot be used.
When changing the Extended Partitioning Mode or Extended Partition configuration, first delete the server from the managed server on the ROR console. Then register the server again after changing the Extended Partitioning Mode or Extended Partition configuration.
