There are methods of "Doing setup" and "Undoing setup" to set from environment settings screen.
Doing setup
Take the following steps to access to the primary management server via the Web browser.
Determine a potential monitoring node of the secondary management server.
Select the [Node environment] tab on the environment setup screen, and select a potential monitoring node of the secondary management server from [Node].
Select [Server environment].
Set [Object of secondary management server automatic migration] to [Yes.]
This setting must be selected from [Node] for all potential monitoring nodes of the secondary management server.
Set the secondary management server to the mode in which a dynamic decision is available.
Select the [System environment] tab.
Select [Yes] from [Secondary management server automatic migration] of the [Secondary server] property.
Set up a group address.
Select the [System environment] tab.
Set "Multicast address" or "Broadcast address" to [Management server group address] of the [Secondary server] property.
Validate settings.
When settings are completed, terminate the environment setup.
The message, "0051 In order to make the settings valid, restart Web-Based Admin View and reconnect it. Are you sure?" appears. If you need to validate the currently chosen value, select [Yes]. Log off, and then login the management server again. If [No] is selected, the setup remains invalid.
Undoing setup
To return settings, access to the primary management server from the Web browser as follows:
Set the secondary management server to the mode in which a dynamic decision is not available.
Select the [System environment] tab from the environment setup screen.
Select [No] from [Secondary management server automatic migration] of the [Secondary server] property.
Validate settings.
When settings are completed, terminate the environment setup.
Then, the message, "0051 Do you wish to restart Web-based Admin View and login again to validate the value?" appears. If you need to validate the value, select [Yes]. If [No] is selected, the setup remains invalid.
Note
The modifications done on the environment setup screen might not be effective if the monitoring node was inactive. In such a case, refer to "7.4.1 Setup by command".
