If you use the virtual interface in NIC switching mode from the shared-IP zone, it is necessary to change the method of deactivating standby physical interfaces by executing the following command:
# /opt/FJSVhanet/usr/sbin/hanetparam -d plumb |
If you stop the zone, return the method of activating or deactivating the interfaces.
To return the method of deactivating the standby physical interfaces, execute the following command:
# /opt/FJSVhanet/usr/sbin/hanetparam -d unplumb |
Note
The setting value is enabled when
the system is rebooted,
the virtual interfaces are deactivated or activated
NIC is switched
Information
The changed value will be enabled in all the virtual interfaces in NIC switching.