In Redundant Line Control function 4.3A10, the following commands are incompatible commands from the previous versions.
In addition, please refer to "Chapter 7 Command reference" about the details of each command.
[Contents]
For the monitoring information for each virtual interface, this changes the status displayed with "Polling Status."
[Changes]
Before modification
If there is even just one enabled HUB monitoring, the "Polling Status" will be displayed as ON.
If there is not even one enabled HUB monitoring, the "Polling Status" will be displayed as OFF.
After modification
If the HUB monitoring for the specified virtual interface is enabled, the "Polling Status" will be displayed as ON.
If the HUB monitoring for the specified virtual interface is disabled, the "Polling Status" will be displayed as OFF.
[Contents]
The condition for settings to be enabled is changed in the case that parameters of the HUB monitoring function are set to the specific virtual interface by using the -n option of the hanetpoll on command.
[Changes]
Before modification
If parameters of the HUB monitoring function are changed after adding the definition of the virtual interface, the settings are enabled after restarting the Redundant Line Control function.
After modification
If parameters of the HUB monitoring function are changed after adding the definition of the virtual interface, the settings are enabled immediately.
