B.1.1 Example of the Single system

This section describes an example configuration procedure of the network shown in the diagram below.

[HOST-A]

1) Setting up the system

1-1) Define IP addresses and hostnames in /etc/inet/hosts file.

192.168.70.1    host11  # HOST-A Physical IP (1)
192.168.71.1    host12  # HOST-A Physical IP (2)
192.168.80.1    hosta   # HOST-A Virtual IP
192.168.70.2    host21  # HOST-B Physical IP (1)
192.168.71.2    host22  # HOST-B Physical IP (2)
192.168.80.2    hostb   # HOST-B Virtual IP

1-2) For Solaris 10
Write the hostnames defined above in /etc/hostname."interface-name" files. If a file does not exist, create a new file.

Contents of /etc/hostname.hme0
host11
Contents of /etc/hostname.hme1
host12

1-2) For Solaris 11
Set the host by the interface used with the ipadm(1M) command and also by the host name defined above.

Interface hme0

# /usr/sbin/ipadm create-ip hme0
# /usr/sbin/ipadm create-addr -T static -a host11/24 hme0/v4

Interface hme1

# /usr/sbin/ipadm create-ip hme1
# /usr/sbin/ipadm create-addr -T static -a host12/24 hme1/v4

1-3) Define the subnet mask in /etc/inet/netmasks file.

192.168.70.0    255.255.255.0
192.168.71.0    255.255.255.0
192.168.80.0    255.255.255.0

2) Reboot

Run the following command to reboot the system. Make sure hme0 and hme1 are enabled as IPv4 interfaces after rebooting the system.

/usr/sbin/shutdown -y -i6 -g0

3) Creation of virtual interface

/opt/FJSVhanet/usr/sbin/hanetconfig create -n sha0 -m t -i 192.168.80.1 -t hme0,hme1

4) Activation of virtual interface

/opt/FJSVhanet/usr/sbin/strhanet

[HOST-B]