Top
PRIMECLUSTERGlobal Link Services Configuration and AdministrationGuide 4.5Redundant Line Control Function
FUJITSU Software
Appendix G Notice of supplemental information > G.3 Troubleshooting > G.3.6 Failure occurs while using IPv6 address (In the case of a Cluster system)
PreviousNext

G.3.6 Failure occurs while using IPv6 address (In the case of a Cluster system)

G.3.6.1 Fails to activate IPv6 takeover address

Phenomenon:

Outputs the following message and fails to activate IPv6 take over IP address.

ifconfig: Duplicate address detected on link hme1 for address fec0:1380::100. Code 1
Cause and how to deal with:

If an IPv6 address is overlapping with the other systems, when attempting to activate an interface, the address overlap detection function causes to stop the activation of a take over IP address. Be sure to check the other systems for over lapping IP addresses.

PreviousNext
Copyright FUJITSU LIMITED 2017