Top
PRIMECLUSTERGlobal Link Services Configuration and AdministrationGuide 4.5Redundant Line Control Function
FUJITSU Software

3.4.1 Fast switching mode

The following shows the procedure for changing configuration information for Fast switching mode:

  1. Inactivate the concerned virtual interface using the "stphanet" command. For information, see Section "7.3 stphanet Command".

  2. Change the configuration information.

  3. After changing the configuration information, activate the concerned virtual interface using the "strhanet" command. For information, see Section "7.2 strhanet Command".

The procedure to change the information of a monitoring function is as follows:

  1. Change the information of a monitoring function using a "hanetparam" command. See "7.6 hanetparam Command" for the detail. In this case, it is not necessary to reactivate a virtual interface. The information becomes valid immediately after changed.

  2. Reboot the system after applying changes.

The following lists the information that can be changed for Fast switching mode. No information can be changed besides the information listed below. Delete the concerned definition and add it again.

When a shared-IP zone is used

If you want to use a virtual interface of fast switching in a shared-IP zone, it is necessary to add the configuration as follows;

  1. Stop the non-global zone.

  2. Inactivate the concerned virtual interface using the "stphanet" command.

  3. Change the configuration information.

  4. Change the network settings of a non-global zone. For information on how to change the zone network settings such as virtual IP address, see "C.5 Configuration Procedure for Redundant Line Switching Mode on Solaris Zones".

  5. After changing the configuration information, activate the concerned virtual interface using the "strhanet" command.

  6. Start the non-global zone.