This section explains a general setup procedure of Oracle database operating on a PRIMECLUSTER system.
Note
Setup procedures in “Chapter 2” explain how to create userApplication newly. If environment has been created in earlier version, in the case of upgrading to 4.5A00, see “Software Release Guide PRIMECLUSTER Wizard for Oracle for Oracle Solaris”.
Standby operation
No | Procedure | |
|---|---|---|
Operating node | Standby node | |
1 | Install and configure PRIMECLUSTER | Install and configure PRIMECLUSTER |
2 | Install PRIMECLUSTER Wizard for Oracle | Install PRIMECLUSTER Wizard for Oracle |
3 | Install and configure Oracle Database software | Install and configure Oracle Database software |
4 | Create userApplication | - |
5 | Create and set up an Oracle database | - |
6 | - | Set up an Oracle database |
7 | Create and set up Oracle resources | - |
For details, see “2.2 Standby Operation”.
Scalable operation (Oracle RAC)
No | Procedure | |
|---|---|---|
One arbitrary node | Other nodes | |
1 | Install and configure PRIMECLUSTER | Install and configure PRIMECLUSTER |
2 | Install PRIMECLUSTER Wizard for Oracle | Install PRIMECLUSTER Wizard for Oracle |
3 | Install and configure Oracle Database software | Install and configure Oracle Database software |
4 | Create and set up an Oracle database | - |
5 | Create and set up Oracle resources | - |
For details, see "2.3 Scalable Operation with Oracle RAC 11g R2/12c R1".
Standby database cluster operation using Oracle Data Guard/Oracle Active Data Guard
For details, see "Appendix G Using Oracle Data Guard/Oracle Active Data Guard".
Single-node cluster operation
For details, see "Appendix F Single-Node Cluster Operation".
