The policies set in the installation procedure and backed up before operations are acted as prerequisites in this place. The "Backup Data" in processing instruction refers to data of backup policies before the operation.
Cause
None.
Action
None.
Cause
The parameters are incorrect when starting the command.
Action
Execute the command again after specifying correct parameters.
Cause
Failed to read the environment setup file "load.inf".
Action
Execute again after restoring the "load.inf" file from the backup data.
[Installation Target of load.inf]
<DTP Installation Directory>\FJSVsbtrs\etc
Cause
The data of the environment setup file (load.inf) was damaged.
Action
Execute again after restoring the "load.inf" file from the backup data.
[Installation Target of load.inf]
<DTP Installation Directory>\FJSVsbtrs\etc
Cause
Failed to read the environment setup file "Server Property".
Action
Execute again after restoring the "Server Property" file from the backup data.
[Saving Target of Server Property]
<DTP Installation Directory>\FJSVsbtrs\data\<Hexadecimal Folder>\
Cause
No Software Dictionary file exists in the folder specified by the parameters.
Action
Execute again after specifying the folder to save Software Dictionary file in the parameters.
Cause
Failed to connect to server.
Action
Execute again after confirming whether the "ITBudgetMGR (INV)" service is started.
Cause
The server is restarting and cannot execute commands.
Action
Wait for the "ITBudgetMGR (INV)" service to restart, and then execute the command again.
Cause
An error occurred in the CS.
Action
Wait for a few moments, and then execute the command again.
If the problem persists, contact the service desk.
Cause
Failed to write when reflecting the software dictionary.
Action
Ensure that the user has write permission for the Software Dictionary file, and then execute the command again.
Cause
The processing for reflecting software dictionary information to the database failed.
Action
Check if the SymfoWARE RDB SWDTP service is running.
If the service is stopped, start it, and then execute the command again.
If the service is running, wait for a few moments, and then execute the command again.
If the problem persists, contact the service desk.
Cause
The software dictionary information is being retrieved from the database, or a security patch is being downloaded.
Action
Wait for a few moments, and then execute the command again.
Cause
The system is trying to apply V15.0.1 or earlier of the software dictionary.
Action
Execute the command again, specifying in the parameter the folder where V15.1.0 or later of the software dictionary is stored.
